Reconditioning Flooded Electrical Appliances
Do not try to use washers, refrigerators or other
large electrical appliances until they are checked by a
serviceman. Attempting to run equipment before it is
properly cleaned could seriously damage it. The
manufacturer's authorized dealer has detailed information
for inspection and repair of his particular equipment,
and should be called for repair if possible.
Follow these general procedures if you must do your
own repairs:
Motorized appliances (refrigerators, freezers,
washers, dryers)
1. Remove the electric motor, if possible, and take it to
an electrical repair shop. If the motor can't be removed,
follow instructions to recondition it.
2. Remove dirt from insulation and dry insulation
thoroughly. Insulation may have been ruined from wetting.
It may develop bad odors, or lose its insulating ability
depending on exposure time in water. If so, the appliance
will probably have to be discarded. Some newer sealed
units may be unharmed by water.
3. Clean up outside of unit, and recondition the controls.
Replace all bad wiring.
4. Clean gear housings and shafts in washing machines
with kerosene. Clean bearings. Wipe metal surfaces with a
kerosene-soaked rag to remove rust and dirt. Coat metal
surfaces thinly with oil.
Heating appliances
1. Disconnect electricity and flush appliance with clean
water.
2. Aerosol cleaning products (like Quik-Kleen) are
available for cleaning hard to reach places in motors.
Spray on parts and wipe or flush off. Do not use on
contacts.
3. The insulation on hot water heaters may be soaked.
Remove all panels, and if possible, the top of the
heater. The insulation may never dry satisfactorily.
4. Clean and dry thermostat and wiring. Apply rust
inhibitor to all metal parts.
Electrical cords
1. Throw away any damaged or fabric-covered cords.
2. Rubber-covered cords in good condition (with no cracks
in the rubber) can probably be reconditioned as follows:
a. Remove connections from both ends
b. Peel back rubber covering until inside braid is
dry.
c. Cut off damaged part of cord.
d. Clean up plug and receptacle; connect to cord
or replace.
Grounding
All metallic appliances should be grounded when in
use to prevent electric shock. This is especially
important with washers, dryers, ranges, waffle irons,
dishwashers, portable drills, saws and grinders. Attach a
wire from the frame of the appliance to a water pipe or
to the ground wire in a grounded wiring system.
**This article was written by Anne Field, Extension
Specialist, Emeritus, with reference from the USDA
Disaster Handbook. |
|
Marco Amidei
888-32-Marco
|
Become a HomesByMarco member
and you'll be able to:
» Save Searches
» Save Properties
» View Market Summaries
» Receive New Home Alerts
Sign Up for FREE!
54 Conway Ct
Grayslake, $187,900
Our HomesByMarco team has helped move
130 families in 2003,
159 families in 2004,
168 families in 2005.
169 families in 2006.
141 families in 2007.
117 families in 2008.
114 families in 2009.
98 families in 2010.
We sell a home every 2.56 days.
"Very satisfied with attitude concerning our Real Estate needs and ability to answer our questions." --Joseph Payawal and Liezl Santos
View More Testimonials
|
